11/25/2023 0 Comments Measure something in cetus3dI have better results with lower flow rates (dia 0.4 or 1900%), but more testing needs to be done. Filament diameters of around 0.38 translate to the 2200% cmeyer posted (flow rate factors in quadratic, so use fine steps when adjusting it). Flow rate percentage adjustments mess up the ‘layer view’ in Cura (from years of experience with an Ultimaker 2, I find this one of the most helpful features in Cura). 400 dollars isnt that much to pay for something bulletproof. I mean guys with descent printers are upgrading to the mk3. Keep in mind that you may have to find a physical solution for levelling the build bed when using Cura.ĭ) With the current version of Cura (v3.3.1) it is better to adjust the flow rate of molten filament via the filament diameter, than the flow rate percentage. (Due to filament sensor and the einsy board) I have a few working ones that have been really well tuned, but there is just not a lot I can do to make them more reliable. The nozzle is too far away from the bed, if the individual lines can be easily separated and do not stick together.)Ĭ) Up Studio allows for an 9-point calibration routine for the z-axis. The nozzle is too close to the bed, if the brim thickness (z-direction) gets to thin and translucent. The CAD models for all the Omron parts were supplied by Omron on their website. It just fits the power supply, temperature controller and the MOSFET board. If you use a brim around a test-model in Cura, the correct height is achieved, if the individual lines that make up the brim squash together nicely. Naturally, I wanted to print the enclosure on the Cetus and so I put something together in F360 which can be found here. (I think a painfully precise calibration is overkill. I did compile my ‘own version’ from the start code by chrisevich. Perhaps the info below will help someone in the future:Ī) I used the start and end code from chrisevich ( #11) which worked nicely for me.ī) the z-axis calibration code posted by cmeyer never worked for me. I just wanted to thank everyone who contributed to this thread - it helped me tremendously when setting up my Cetus3D MkII with Cura. G1 X50 E360 F300 extrude a 5cm purge line G1 X2 Y178 F5000 move to back right corner Actual Size Online Ruler (inches, cm/mm) measure something on-screen measuring tool in inches/centimeters Calibrate If you want to measure the actual size of a small object in inches or centimeters and you don’t have a real ruler at hand, this virtual on-screen online ruler will help you. M206 X-180 offset X axis so the coordinates are 0.180, normally they are -180.0 Do the paper test and use a gcode file something like this:p.p1 the nozzle offset may be different than in Cetus Studio. make sure your nozzle offset is correct in the starting g-code
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |